Media Devices

HP DRAFTMASTER DRIVER

Right edge was found; however, media skew was detected. The display on the front panel may also indicate an X- or Y-Axis failure. Promote cracked software, or other illegal content Offensive: Make certain of the setting of the plotter’s serial port to the factory defaults. Plotter parts have been changed pinch wheels, for example. Asia Pacific and Oceania. Press f3 to display the user letter.

Uploader: Mazunos
Date Added: 13 July 2015
File Size: 54.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18974
Price: Free* [*Free Regsitration Required]

Remove any currently loaded media including torn scraps and then load a new, unwrinkled sheet of media. Roll feed supply roll out of media. An authorized service dealer should service the plotter.

Typically caused by improper alignment of the right edge of the media with the front eraftmaster rear paper stops.

Now select Properties and then select the Details tab. The display on the front panel may also indicate an X- or Y-Axis failure.

This post has been flagged and will be reviewed by our staff. Fix by replacing the draftamster carriage assemble. Rotate the page 90 degrees clockwise and reload the media in the plotter. Plotter parts have been changed pinch wheels, for example. Raise the paper-loading lever.

Related Articles  INTEL DQ965GF LAN DRIVERS DOWNLOAD

HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots

Conditions causing a Z-Axis Failure message to appear on the front panel of the HP DraftMaster family plotters, and how to alleviate the problem. Demonstration plot The demonstration plot checks most of the mechanical and electrical workings of the plotter. Thank you for helping us maintain CNET’s great community. Main cause is stiction in the Z-Axis. Load three fiber-tip pens in the carousel and configure the carousel to use fiber-tip pens.

HP Computer Museum

This page requires Javascript. Please try again shortly. Europe, Middle East, Africa. Align the white arrow on top of the left pinch wheel with the left side of the media.

Follow the above procedure. If it does not have a paper cutter, use a sharp blade or another cutting device. Make sure that the fraftmaster serial port settings are set to the factory defaults.

Turn the plotter off and then on again before plotting.

Convert The HP DraftMaster RX Pen Plotter Into a Vinyl Cutter! | | Do It Easy With ScienceProg

Solving media load problems in the HP DraftMaster family plotter. Conditions causing a Y-Axis Failure message to appear on the front panel of an HP DraftMaster family plotter, and how to alleviate the problem.

Related Articles  U.S.ROBOTICS V.92 PCI FAXMODEM DRIVERS FOR WINDOWS 7

Modify your browser’s settings to allow Javascript to execute. There is so little to be learned from this old tech except that it was dismissed for very good reasons.

Convert The HP DraftMaster RX Pen Plotter Into a Vinyl Cutter!

Carefully align the line on the left pinchwheel with the left edge of the media. The message Calibrating will display. Remove the media from the plotter. Got a discussion topic that’s not necessarily related to technology?

Load a sheet of E or D size polyester film in the plotter. hl

If paper is visibly jammed in the grit wheel or rollers, draftmasteg the obstruction may alleviate the problem. Five conditions exist that may cause a “Check Pen and Paper” error to occur:.

Javascript is disabled in this browser. This error condition will not interfere with plotter operations.